Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

B-size plotter/printer

Thread starter Dave K
Start date Jun 9, 2015

Status: Not open for further replies.

Jun 9, 2015

Dave K

Automotive

NX 9 TC 10.1

We are looking at some new printer/plotter hardware, something closer to desk size, that we can get 1:1 B-size drawings.

I know setting up a "printer" to work as a "plotter" can be a headache sometimes, has anyone had good results, with minimal headache with anything? This could be sheet feed, or a sheet feed with a 24" roll. Just looking for models that work.

Thanks,
Dave

-Dave

NX 9, Teamcenter 10