Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Automated spin/zoom model in Creo Parametric 2.0
- Thread starter IntelGDR
- Start date
munchichee
Mechanical
You can use orient mode to spin the model and just record a mapkey of it. If you want to get fancy create an animation by using "drag components" in the animation application and make snapshots of your assembly at several different positions you want to animate. Use advanced drag options to control it. Then create new key frame sequence and specify which snapshots to use at specific times. Play.
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question