Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AutoLISP-double precision for point coordinates

  • Thread starter Thread starter ancisai
  • Start date Start date
Status
Not open for further replies.
A

ancisai

Guest
Ciao!

How can I set the precision for point coordinates ,which I get with entget function? I need doble precision.
 
AutoLISP Precision

Hello ancisai,

You always get the full available precision (14-15 decimals) with
AutoLISP. Only the printout rounds it to less precision. This rounding is controlled by LUPREC and DIMZIN.

When creating the points, use the UNITS command to set the operating precision.

Good luck!
3DCADTips Help Desk :cool:
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top