Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AUTODESK ILOGIC VS SOLIDWORKS DRIVERWORKS?

Status
Not open for further replies.

hookooekoo

Industrial
Jun 19, 2012
2
Hello.


im using autodesk ilogic to automate models, so , anybody here have been used driverworks? i want to compare this solutions.


thanks in advance.
 
Replies continue below

Recommended for you

Inventor = Solidworks.. They are virtually identical.
Of course you can always get a demo of Solidworks and find out for yourself (because a comparison requires YOU to do the pro's/con's and decide what YOU need or don't need)..

I'm sure there are also numerous videos on youtube,etc... to give you the basics. (I just watched one.. and seems again to be "virtually identical" to ilogic)
 
Autodesk has a lot less useful feature than SW, lot of what ilogic is been used for is to replicate these features...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor