Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AutoCAD to PDMS

Status
Not open for further replies.
may0511

may0511

Mechanical
Joined
Sep 4, 2003
Messages
6
Location
A2
I have been using AutoCAD for Six(6) years now and wishes to go for a PDMS training. Please can anyone advise me if there are job prospects in PDMS. The training is expensive and I would like to have a Return On my Investment.
 
Sort by date Sort by votes
there is a job prospects in PDMS. an piping designer should know how to use PDMS and PDS.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

W
  • Question Question
Orifice for dump line to liquid tank
Replies
10
Views
9K
Whatsanolet
W
mariolucas75
  • Locked
  • Question Question
NDT Prior to welding
Replies
8
Views
4K
Dhurjati Sen
Dhurjati Sen
jafary64
  • Locked
  • Question Question
Settlement of SS Pipe to Sleeper
Replies
2
Views
4K
EngrPaper
EngrPaper
C
  • Question Question
How to Air-Seal Oval Tube into Hole!
Replies
5
Views
716
chuwiEngineer
C
bizkitgto
  • Question Question
When would piping need to be replaced due to an overpressure event where the Yield Stress was exceeded?
Replies
15
Views
10K
GD2
GD2

Part and Inventory Search

Sponsor

Back
Top