Help! I am on a tight schedule to get my Patented prototype heatsink ready for production. I am trying to fit more heat fins on the heatsink. Right now I have only 52 fins, I need 96+. The fin patterns are in a circular pattern on a square block. I cant get autoCAD to segment the concentric circle pattern more than 4 times. I need to segmet the circular pattern 8 times. The circles lie within the square box so it makes it very difficult to surther segment the circles. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
AutoCAD 2004
- Thread starter apoc1
- Start date
diamondjim
Mechanical
Why not make a sector equal to
45 degrees trim the circles
and then array the pattern?
45 degrees trim the circles
and then array the pattern?
- Status
Similar threads
- Locked
- Question
