Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AutoCAD 14 units

Status
Not open for further replies.

PhilGooch

Mechanical
Joined
Feb 26, 2002
Messages
9
Location
GB
Why is it that when I start a new drawing, having selected "metric" then create a dimension, then modify the properties of the units it still says feet and inches??
 
It has been a while since I have had to use metric settings on AutoCad. But if I recall, you need to change metric to a default setting in your setup menu.

Live Aloha Frank M.
Tradewind Resources
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top