Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ATOM Flashcut

Status
Not open for further replies.
shaffer1921

shaffer1921

Materials
Joined
Jun 19, 2013
Messages
1
Location
US
Hello Everyone,

I have an ATOM Flashcut System, and recently the bed slightly bubbled/warped upward near the foot of the bed.

It warped enough that the blade cut the profile we were cutting into the bed, so there is a nice etching in several locations about .02" deep or so.

Has anyone out there had a similar problem?
 
Status
Not open for further replies.

Similar threads

aleALI
  • Locked
  • Question Question
ATOM Flashcut Specs
Replies
0
Views
124
aleALI
aleALI
brianlaser
  • Locked
  • Question Question
oscillating-knife cutting (ATOM Flash cut)
Replies
2
Views
329
brianlaser
brianlaser

Part and Inventory Search

Sponsor

Back
Top