Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASTM E230

Status
Not open for further replies.
Cooter18

Cooter18

Industrial
Joined
May 15, 2018
Messages
1
Location
US
ASTM E230 Table 1
NOTE 2—At a given temperature that is expressed in °C, the tolerance expressed in °F is 1.8 times larger than the tolerance expressed in °C. Where tolerances are given in percent, the percentage applies to the temperature being measured when expressed in degrees Celsius. To determine the tolerance in degrees Fahrenheit, multiply the tolerance in degrees Celsius by 9/5.

Does this mean that Standard Tolerance for a K T/C in °C is +/-.75% (per chart) and for °F is +/-1.35%?

Thanks in advance
 
Status
Not open for further replies.

Similar threads

Wickerfields
  • Locked
  • Question Question
ASTM F1960, Sub Reference D2122-98
Replies
2
Views
1K
SWComposites
SWComposites
G
  • Locked
When I looked at the specification ASTM C33 I did not find the specification limits for the 1/2-inch sieve as mentioned in the
Replies
0
Views
1K
GHADA ALQARESH
G
Muhammad Ijaz
  • Locked
  • Question Question
Availability of 3mm thick As rolled ASTM A516 70 plate normalized and impact tested
Replies
0
Views
1K
Muhammad Ijaz
Muhammad Ijaz
Rubje
  • Locked
  • Question Question
ASTM A7, A30, A70
Replies
1
Views
1K
Dhurjati Sen
Dhurjati Sen
MujtabaQA
  • Locked
  • Question Question
Who can explain about Thin-wall pipe as per ASTM standard
Replies
6
Views
2K
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top