Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
ASTM A350 LF6 Class 2 vs NACE MR0175
- Thread starter Dinu Stan
- Start date
It doesn't have to be listed, it's a low alloy steel. Look under Part 2, Annex A, A.2.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
Steve Jones
Corrosion Management Consultant
All answers are personal opinions only and are in no way connected with any employer.
If you see A.2.1.1 of NACE MR 0175, you find an answer.
(Quoted from A.2.1.1 of NACE MR 0175)
The majority of steels that comply with the general requirements of A.2 are not individually listed; however, for convenience, some examples of such steels are listed in Table A.2, Table A.3 and Table A.4.
Lee SiHyoung,
(Quoted from A.2.1.1 of NACE MR 0175)
The majority of steels that comply with the general requirements of A.2 are not individually listed; however, for convenience, some examples of such steels are listed in Table A.2, Table A.3 and Table A.4.
Lee SiHyoung,
- Status
Similar threads
- Locked
- Question
- Locked
- Question
