hknshn
Mechanical
- Jun 19, 2012
- 1
Hello,
I have an out put file that consists of x,y,z coordinates and Pressure coefficients.
(Pressure differences were found from the formulation of aerodynamics.)
The file that I mentioned above must be used on Ansys workbench for defining forces on the geometry by the help of SFE command.
Can somebody help me how I can do this ?
Best regards
I have an out put file that consists of x,y,z coordinates and Pressure coefficients.
(Pressure differences were found from the formulation of aerodynamics.)
The file that I mentioned above must be used on Ansys workbench for defining forces on the geometry by the help of SFE command.
Can somebody help me how I can do this ?
Best regards