Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASSEMBLY_SECTION_LARGE_ASSY_NX8.0.2

Status
Not open for further replies.
mathisudar2007

mathisudar2007

Automotive
Joined
Aug 1, 2012
Messages
100
Location
IN
Hello,

I have opened a large assembly under the light weight representation and use the Section command(view-section-new section).

The output in the 2d section curves varies lot.How to minimize this variation in light weight mode?

When I change to Exact mode then the results are OK.I have attached the supporting image here to explain the same.Also,what impact/performance/memory issues it creates if I change always the Excat mode during the section.


Thanks and regards,
Mathi Krishnan.



 
Sort by date Sort by votes
Hello,

Any answers for this query?

Thanks,
Mathi K
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top