Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Assembly mirror

Status
Not open for further replies.
m1mason

m1mason

Mechanical
Joined
Jul 1, 2004
Messages
172
Location
US
I know how to mirror at Part level(Insert>Mirror part)

But, How do you do it in Assembly mode where you have more than one componant? or if you have a Sub-assembly?

Thanks,

Mark
 
Sort by date Sort by votes
You will need to select a plane to mirror it around tho, and you will then have to constrain it, otherwise it will just float about.
 
Upvote 0 Downvote
Man, I'm getting a little rusty. Thanks guys
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

K
  • Question Question
Solidworks Assembly - Using Mass Properties of part instance to control dimensions of parts in assembly
Replies
3
Views
3K
jassco
jassco
JerryWong
  • Locked
  • Question Question
Hole callout in mirror part
Replies
4
Views
1K
SBaugh
SBaugh
K
  • Locked
  • Solved
Image of assembly component in userform macro vba
Replies
12
Views
7K
koubaleite
K
jassco
  • Locked
  • Question Question
Solidworks VBA to GET and SET dimensions on a sketch in an assembly model
Replies
1
Views
2K
jassco
jassco
K
Part / Assembly practice
Replies
0
Views
3K
kpinks
K

Part and Inventory Search

Sponsor

Back
Top