Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Assembly Mate

Status
Not open for further replies.

Bhaveshn

Mechanical
Joined
May 23, 2007
Messages
72
Location
CA
How I can connect edge on face?
 
You've said it already: A connect!
 
Hi,

Use a Connect relationship between the first extremity vertex of your edge to the target plane (V20 SP7 helps because vertexes regained higher priority). Then connect the other extremity vertex to the same plane.

You can also draw a sketch on the plane and use the Axial align relationship between the sketch segment and the edge.

HTH,

Fred
 
Hi Fred,
Thanks for solution.

Is there any direct way instead of using two extreme vertex or sketching? I know, even elementry cad packages have this ability.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top