Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Assembly Instances

Status
Not open for further replies.
kwkmts

kwkmts

Mechanical
Jan 29, 2007
25
Im trying to create an assembly that has the same parts but the mating scheme is different. Is there any way that I can make an instance of each, if so how would i go about doing that? Im running Wildfire 2.
 
Status
Not open for further replies.

Similar threads

J
  • Locked
  • Question
How to disable auto snapping in assembly?
Replies
1
Views
2K
3DDave
3DDave
whatev-nvm
  • Locked
  • Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
DesEngineer4
  • Locked
  • Question
THREAD Check in Assembly 1
Replies
2
Views
444
3DDave
3DDave
shanemolloy
  • Locked
  • Question
Replacing a component in an assembly based on excel
Replies
0
Views
302
shanemolloy
shanemolloy
dejan95
  • Locked
  • Question
How to configure a variety of assembly state in Creo Parametric
Replies
1
Views
438
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom