Assembly Explode Speed

[johni]

If this subject was discussed previously, forgive me, but I was wondering if anyone could help me with how I can manage the speed at which an assembly explodes. After updating to CREO 2.0, the time it takes our assemblies to explode is probably less than a second. Previously, our assemblies exploded at a slower speed to where you could see the components moving, thus getting a better understanding of how the components interact with each other. If anyone could post whatever it is that needs to be set, whether it's in the config file or just a setting in the program, it would be appreciated.

 

[dross]

My explodes have always been instantaneous no matter what version of Pro I'm running.


Maybe it's your graphics card?


Did you change anything on your computer when you went to Creo?

 

[dr_gallup]

First time I've ever heard anybody say anything happens faster in Creo!

 

[johni]

The computers are new with very good graphics cards. I'll keep doing some research to see what if any settings control the speed at which the assemblies explode.

 

[dross]

Does that mean that your old computers were slow with not so good graphics cards?


If so, that is probably why.