Assembly Animation of a Aircraft Radial Engine using SW & KS

[Dcabral]

Hello there,

I used Solidworks to prepare the CAD assembly and then used Keyshot to render this animation (and After Affects to finalise the video)
The experience was very good but it was however very time consuming as I am curious if this would have been achieved easier/faster if I was to use a different CAD software?

https://youtu.be/w6PgUx6LZVM

https://youtu.be/tTK8IfTRuQ0

I am open to feedback and suggestions :-D

You can see more examples of my work check out my Web-Portfolio:
www.dancabraldesign.com