Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Section VIII Div1 Weld Seam Width

Status
Not open for further replies.
oguzzz

oguzzz

Mechanical
Joined
Mar 1, 2020
Messages
15
Location
TR
Hi,

What is the weld seam width tolerance for as welded longitudinal and circumferential joints according to ASME SecVIII Div1.
 
Sort by date Sort by votes
Generally the Code does not address such tolerances. It will be a factor of joint design/thickness.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
13K
victor6397
victor6397
A
  • Locked
  • Question Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
5K
antoniol
A
A
  • Locked
  • Question Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
2
Views
2K
antoniol
A
timsch
  • Question Question
Question of scope of ASME BPVC SECTION IX
Replies
1
Views
9K
DekDee
DekDee
YuJie_PV
  • Question Question
some questions regarding the buckling analysis(5.4 of ASME VIII-2)
Replies
3
Views
10K
TGS4
TGS4

Part and Inventory Search

Sponsor

Back
Top