Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME SEC VIII, DIV 1,

Status
Not open for further replies.
Faisal88

Faisal88

Industrial
Joined
Feb 9, 2018
Messages
1
Location
MY
May i know in this section, where is the clause for Hydro-static test procedure other than UG99.?
 
Sort by date Sort by votes
Nowhere. Even though the word or wording hydrostatic test is found elsewhere in the code, only UG-99 deals with the hydrostatic test procedure. UG-101 also deals with a test procedure where a liquid (i.e. hydro) is involved, but it aint the hydrotstatic test we all commonly refer to.
 
Upvote 0 Downvote
Even UG-99 is not a procedure, as such, just a collection of requirements.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
14K
victor6397
victor6397
jayinwww
  • Locked
  • Question Question
ASME Sec VIII Div 1 full pen weld on a mixer
Replies
4
Views
781
weldstan
weldstan
victor6397
  • Locked
  • Question Question
Fatigue analysis for C95800 in ASME BPVC Sec VIII div.2
Replies
1
Views
676
TGS4
TGS4
R
  • Question Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance
teokal
  • Locked
  • Question Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
2K
teokal
teokal

Part and Inventory Search

Sponsor

Back
Top