ASME Sec. I / NDT / PW-11 / Table PW-11

[MhmdNfri]

Hi everybody,

according to ASME Sec. I,
do not we need any NDT for WATERTUBE BOILERS in the following situation:
- Pipe-to-pipe
- Circumferential weld
- NPS 10 (DN 250) (OD 27,4)
- Wall thickness 12,7mm
- Not Subject to Furnace Radiant Heat
- Contains Water
?

According to table PW-11, it is not required and
in PW-11 last paragraph it says:
" Experience has demonstrated that welded butt joints not requiring volumetric examination by these rules have given safe and reliable service even if they contain imperfections that may be disclosed upon further examination".

Is it correct if I prepare a "weld/NDT-Map" for this weld line without NDT?

Thanks in advance!

 

[r6155]

Is it correct if I prepare a "weld/NDT-Map" for this weld line without NDT?

Incorrect, visual examination is required.