Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME MFC-3M

Thread starter pecan204
Start date Sep 25, 2006

Status: Not open for further replies.

Sep 25, 2006

pecan204

Mechanical

Hello,

Can anyone give me an opinion on the straight lengths of pipe required in Table 2 for a natural gas orifice metering run?

Immediately upstream is a filter (not covered by table 2).

I assumed there would be no swirl in the flow coming out of the filter. Thoughts?

The line diameter is 4.0 inch sch 40.

Thanks
Ken