Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME Code & Spot Welds, Quality and Fatigue Factors

Status
Not open for further replies.
tstacctmechengr

tstacctmechengr

Mechanical
Joined
May 10, 2013
Messages
1
Location
US
What are the appropriate quality and fatigue factors for spot welds? The component is not bound to the ASME code, however, I am planning on using a quality factor of 0.3 & fatigue factor of 4 from the NG3000 for a plug weld. The factors for a plug weld would be used since it is a comparable to a spot weld. The component is 304L SS being resistance spot welded to a 304 SS. Any suggestions or ideas of other codes I should be looking at?
 
Status
Not open for further replies.

Similar threads

victor6397
  • Locked
  • Question Question
Elastic-plastic fatigue assessment ASME VIII-2
Replies
0
Views
1K
victor6397
victor6397
YuJie_PV
  • Question Question
factors to be considered for vessels in cyclic service
Replies
10
Views
8K
YuJie_PV
YuJie_PV
M
  • Locked
  • Question Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
3K
Mecat24
M
Khalid Hameed
  • Locked
  • Question Question
ASME B 31.3 and ASME B31.8
Replies
4
Views
2K
Khalid Hameed
Khalid Hameed
hugo50ml
  • Locked
  • Question Question
Concerns Regarding ASME Certification and Company Conduct
Replies
0
Views
2K
hugo50ml
hugo50ml

Part and Inventory Search

Sponsor

Back
Top