Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B31.8 and DNV RP-F112

Status
Not open for further replies.
farhanidris

farhanidris

Mechanical
Joined
Aug 13, 2013
Messages
1
Location
SG
thread292-268791

I am trying to figure out the correct procedure to obtain membrane stress and membrane + bending stresses from the B31.8 stresses obtained in Autopipe. Do i need to do it in ANSYS or can i do manual calcs. Has anyone figured a way to do this?

Thanks.
 
Status
Not open for further replies.

Similar threads

Khalid Hameed
  • Locked
  • Question Question
ASME B 31.3 and ASME B31.8
Replies
4
Views
2K
Khalid Hameed
Khalid Hameed
engineer0
  • Question Question
ASME B31.8 vs 49 CFR 192 Subpart D - Design of Pipeline Components
Replies
1
Views
8K
A.egis
A.egis
hugo50ml
  • Locked
  • Question Question
Concerns Regarding ASME Certification and Company Conduct
Replies
0
Views
2K
hugo50ml
hugo50ml
Samingme755
  • Locked
  • Question Question
Asme B16.47 series A and B
Replies
1
Views
3K
LittleInch
LittleInch
Karik87
  • Question Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
1K
Karik87
Karik87

Part and Inventory Search

Sponsor

Back
Top