Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B 31.3 para 345.2.6 1

Status
Not open for further replies.

Freddy73

Mechanical
Mar 7, 2001
8
MX
In accordance with ASME B31.3-1996 Edition, para. 345.2.6, what does "minor repairs o additions" mean?
 
Replies continue below

Recommended for you

This is up to the owner to decide, nothing is defined by the standard.
In my opinion the repair of a leaking weld in a main run or the addition of drains with relatively large diameter would be major changes, whereas the insertion of a threadolet for a small drain or vent, if properly ND tested and assuming no PWHT requirements apply, could be considered a minor change.
prex
motori@xcalcsREMOVE.com
Online tools for structural design
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top