ARRANGEMENTS

[jkcone]

Hello,
I'm using "arrangements" for the first time.
In a nut shell is the scope of what arrangements do is to turn on & off different sets of assembly constraints & that's all?

Thanks,
James

 

[Aerohawk]

Hi stormyb, check this: thread561-317434
- Covered something on using 3D angle vs orient which should be helpful to you.

Hi John,
You seem to be a big contributor on the forums and very knowledgeable about NX. Was wondering if you had a solution to my arrangements question above: "Unable to edit the arrangement positiong on some components"

Would be great to get your opinion on how I could fix this.

Thanks
Vik

 

[JohnRBaker]

What you've bumped into is a bit of a gap in the current capabilities. We're aware of the need to enhance this but at the moment I can't really offer much advice other than going back and changing each arrangement individually.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.