Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Area Moment of Inertia in V5 ?
- Thread starter jhodges
- Start date
Hi Johnny!
Create a plane where you want the moments of inertia for your section cut. Go in the sketcher mode use the "intersect 3D elements" icons select your body (you'll have the complete boundary of your part). Switch to surface then simply fill this boundary (Fill function). After do an inertia analysis of this new surface.
Hope this help!
Kev
Create a plane where you want the moments of inertia for your section cut. Go in the sketcher mode use the "intersect 3D elements" icons select your body (you'll have the complete boundary of your part). Switch to surface then simply fill this boundary (Fill function). After do an inertia analysis of this new surface.
Hope this help!
Kev
- Status
