Archived ASME stress table in 1969?

[ALangley]

Hi all,

I'm currently on a re-rating job of a pressure vessel designed in 1969. I therefore am looking for the ASME part D maximum allowable stress tables that were effective during that time. Where can I find the code/stress tables?

Thank you so much!

 

[Christine74]

ASME did not have a Section 2 Part D in 1969. The allowable stresses were an integral part of Section VIII. The allowable stresses for carbon and low allow materials for Section VIII Division 1 are listed in Table UCS-23.

If you don't have the 1969 Edition of the code, you might be able to order it here:

https://www.nationalboard.org/Index.aspx?pageID=290

-Christine