Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Applying a load until peak stress?

Status
Not open for further replies.
metalman8357

metalman8357

Materials
Joined
Oct 5, 2012
Messages
155
Location
US
Hi all,

I have a part that I'm loading in tension and I'd like to simulate a tensile test. I'd like to load the part at a displacement rate of 0.1 in/min until a target von mises stress value is reached. How do I go about doing this? I'm new to ASM so bare with me...

On a related note, if I run a simulation, is it possible to have a load curve genreated that plots max stress vs displacement?

Thanks,
M
 
Status
Not open for further replies.

Similar threads

s.saletic
  • Locked
  • Question Question
Algor from MS-DOS era
Replies
0
Views
2K
s.saletic
s.saletic
PJ18
  • Locked
  • Question Question
Autodesk Simulation Mechanical Accuracy
Replies
0
Views
813
PJ18
PJ18
Boghi1990
  • Locked
  • Question Question
Thermal Stress Analysis Model Constraints
Replies
0
Views
766
Boghi1990
Boghi1990
Boghi1990
  • Locked
  • Question Question
Main Steam Lines Thermal Stress Analysis
Replies
0
Views
849
Boghi1990
Boghi1990
Boghi1990
  • Locked
  • Question Question
Circumferential, Radial & Axial Stresses , Output Results Algor Autodesk Mechanical Simulation
Replies
1
Views
830
barrti
barrti

Part and Inventory Search

Sponsor

Back
Top