Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Apply Wind Load Pattern using CSIBridge

Status
Not open for further replies.

yaroosh

Structural
May 11, 2015
32
Hello Everyone,

I am trying to add Wind Load on my bridge using CSI Bridge. I have defined the wind load patterns; I also tried Bridge Wind loads under bridge object.
Still I am not getting any response. I thought about applying it using area assign loads, but I am not sure if this is the correct approach. Have any one used the automated CSI Bridge wind load pattern before?

Thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor