Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

APPENDIX Y, g1 and g0 values, when having no hub.

Status
Not open for further replies.
takio

takio

Mechanical
Joined
Jul 9, 2019
Messages
37
Location
CA
Hello,

When calculating g1 and g0, if there is no hub. are they 0? or do they have the same value as shell wall thicknesses for both of them?
Can they have the values if welding makes a small hub?

Thank you
 
Status
Not open for further replies.

Similar threads

nashki
  • Question Question
Thickness Hub at the Small End, g0
Replies
5
Views
8K
r6155
r6155
Vrpeng-tips
  • Locked
  • Question Question
U2-(g), appendix 46
Replies
16
Views
10K
Vrpeng-tips
Vrpeng-tips
C
  • Locked
  • Question Question
ASME VIII-1 Appendix 2 integral flange (Figure 2-4, Sketch 5/6/7) - hub internal to shell boundary permissible?
Replies
12
Views
4K
COpressurepipe
C
YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV
mechengineer
  • Locked
  • Question Question
ASME VIII-1 Appendix 2 and ASME PCC-1 with API 660 table 3
Replies
0
Views
842
mechengineer
mechengineer

Part and Inventory Search

Sponsor

Back
Top