Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AntiSnap?

Status
Not open for further replies.
iumcad

iumcad

Mechanical
Jan 23, 2007
30
I am a solid works newbie who just purchased and installed 2007 SP2.2. Everything seems to be fine except for the snaps in sketch mode. Upon initially drawing a line I cannot snap to anything. If I draw a rectangle then drag points they will snap. But on the initial start of a line, circle, rectangle etc. It will not attach to any snap point . Automatic relations, enable snapping, snap to model geometry are all on. I have already tried a re-install as well. Any suggestions?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
See what your settings are under tools>options>system options>sketch>relations-snaps
 
Upvote 0 Downvote
Make sure you don't have anything selected in the Selection Filter toolbar.

Is your video card and driver certified by SW?

[cheers]
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom