Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Antifoam injection in feed line (Delayed Coker)

Status
Not open for further replies.

rumirav

Petroleum
Joined
Dec 22, 2011
Messages
31
Location
ES
Hello,
Silicon.based antifoams (PDMS) is routenily injected in the top of coker drums to reduce foam height. However, it has been claimed by some refiners that injecting the antifoam directly with the vacuum residue in the feed line, before entering in the drum, is more efective, with a fast response and a lower dossage required.
Has anybody experience with this kind of injection? If so, which is the optimum injection point and which are the issues that must be taken into account?
Thank you very much for your help
Best regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top