Ansys Workbench Error

[Ot7s]

Hi everyone !!
I’m a biomedical engineer recently graduated and I’m currently working on an explicit dynamic simulation. I’m not really familiar with Ansys workbench and I get an error message while running the analysis. The message is : "An error occurred when the post processor attempted to load a specific result. Please review all messages."
Can someone give me a hand?
Thanks a lot!

 

[wcc82]

For me this error has always occurred after a solve when trying to load a result from an invalid timestep. This usually occurs when I have disabled some of my timesteps and re-solved the model and neglected to change the "Display Time" in one or more of my result objects. Either setting the "Display Time" to 0 (zero) or inputting a valid timestep will make this error go away. Also, if any of your result objects have this situation you will get that error message so you have to make sure you have the correct "Display Time" set on all of them.