Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys with Hypermesh support

Status
Not open for further replies.
eXileTM

eXileTM

Mechanical
Joined
Sep 27, 2012
Messages
6
Location
HU
Hello!
I have just started to learn the Hypermesh, and some questions have come up.
How can I export the geometry with the FE modell to Ansys WB? If I export only the Mesh, then Ansys can generate a model to it, but it doesn't contain lines (which i had in hypermesh).
Which software is it recommended to define contats with?

Thanks,
Peter
 
Status
Not open for further replies.

Similar threads

S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
somebodyfromworld
  • Locked
  • Question Question
ACT extensions for Ansys
Replies
0
Views
1K
somebodyfromworld
somebodyfromworld
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top