Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys hex mesh

Status
Not open for further replies.
annamacc

annamacc

Structural
Joined
May 14, 2015
Messages
11
Location
IT
Hi there

If in Ansys I have to mesh a complex geometry with hex mesh method there is a way to do it?
Because I tried but error messages appear, (if instead I do in "tet" the programme allows me )
 
Sort by date Sort by votes
Hex mesh is only possible for mappable/sweepable geometry. Try to slice your geometry so that you have only mappable/sweepable volumes, then Ansys can create a hex mesh.

Best regards
Alexandru Dadalau

MESHPARTS GmbH
Tuning Your Simulation
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
generating mesh
Replies
2
Views
7K
Ahmad_f88
A
O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
somebodyfromworld
  • Locked
  • Question Question
ACT extensions for Ansys
Replies
0
Views
1K
somebodyfromworld
somebodyfromworld
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X

Part and Inventory Search

Sponsor

Back
Top