Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS file structural analysis ERROR

Thread starter snkadati
Start date Jun 27, 2012

Status: Not open for further replies.

Jun 27, 2012

snkadati

Aerospace

"The value of UY at node 279 (the node changes depending on where I put forces and constraints) i2 2.849378589E+11. It is greater than the current limit of 1000000. This generally indicates rigid body motion as a result of an unconstrained model. Verify that your model is properly constrained."

any help me?

i attached the file bellow