Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS- Deformed Shape Model Processing.

Status
Not open for further replies.
dthanoon

dthanoon

Mechanical
Joined
Mar 2, 2010
Messages
4
Location
FR
I wonder if it is possible to export the meshed deformed shape resulted from a static analysis (i.e. a displacement analysis) so it can be:
- first used to proceed some geometry processing (for instance remove from this deform geometry a sphere of center C=(CX,CY,CZ) and radius R)
- and then from this post process deform geometry proceed to a new static analysis.
Note that this is different from only an UPGEOM or UPCOORD command since I need to post process my deform geometry.
Thanks
 
Status
Not open for further replies.

Similar threads

O
  • Locked
  • Question Question
ansys civata
Replies
0
Views
2K
oktaeng1
O
S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
V
  • Locked
  • Question Question
Boundary conditions and post processing for Planar tension test
Replies
0
Views
582
vsw
V
vickyiamlucky
  • Locked
  • Question Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
721
vickyiamlucky
vickyiamlucky
somebodyfromworld
  • Locked
  • Question Question
ACT extensions for Ansys
Replies
0
Views
1K
somebodyfromworld
somebodyfromworld

Part and Inventory Search

Sponsor

Back
Top