Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS Composite Material Design

Thread starter Yousra176
Start date Feb 26, 2013

Status: Not open for further replies.

Feb 26, 2013

Yousra176

Marine/Ocean

Hi,
I am Preparing a midship section by using the Ansys for a composite material boat, I am using Shell 181 for the hull shell & Solid 185 for the foam core stiffeners , shall I used a contact between the hull shell 181 & Solid185 or there is a way to glue them together?
Thanks