Hello Everyone!
I tried to model a composite pressure vessel using Ansys ACP. The identical lay-up was applied for the side of cylinder and the dome part at the junction. However, it seems that the thickness of some layers at the junction converges to 0 after I generated the solid model in ACP. I would appreciate it if you would answer the question.
Best regards
I tried to model a composite pressure vessel using Ansys ACP. The identical lay-up was applied for the side of cylinder and the dome part at the junction. However, it seems that the thickness of some layers at the junction converges to 0 after I generated the solid model in ACP. I would appreciate it if you would answer the question.
Best regards