Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSYS 16.1 Workbench Mechanical Legend Display

Thread starter dobbertz
Start date Jul 8, 2015

Status: Not open for further replies.

Jul 8, 2015

dobbertz

Mechanical

Hey all,

So I'm pretty new to using ANSYS, and I'm getting the hang of it pretty well so far! I'm hoping this question has a fairly simple answer that I just can't find.

I'm pulling screenshots from my results to put into a report, and my boss requested that I increase the font size of the legend to make it easier to see.

This is what I'm looking at right now: