Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSI/ASME Flanges 1

Status
Not open for further replies.
dskjockey1

dskjockey1

Mechanical
Joined
Jan 17, 2012
Messages
12
Location
US
Can I machine off the RF of a standard ANSI B16.5 flange without affecting the pressure rating of that flange? How about machining off 1/3 of the RF height?

Thanks!
 
Sort by date Sort by votes
dskjockey1, this has been discussed previously, probably numerous times. Try a site seach?

Regards,

Mike
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
Tmoose
  • Locked
  • Question Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
986
Tmoose
Tmoose
Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
Quality Improvement 1
  • Locked
  • Question Question
ANSI Standard requiring changing part number vs revision
Replies
3
Views
1K
looslib
looslib
apolq
  • Locked
  • Question Question
DIN vs ANSI (mating flanges)
Replies
1
Views
959
mk3223
mk3223

Part and Inventory Search

Sponsor

Back
Top