Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Another Question

Status
Not open for further replies.

djw2k3

Mechanical
Joined
Jan 20, 2003
Messages
190
Can I exclude components from being sectioned in a broken out view?

ie similar to using the standrad section tool. :^)

Dave
 
Broken Veiw is just extension of View with horizontal & vertical Breaklines. So it should be possible to exclude (i.e. Hide) components
 
ops forgot to add - SW2001+
 
No there is no way to directly to exclude components from a break view in SW01+. You can however hide certain parts in the view itself. RMB\Properties\Hide-Show components.

Regards, Scott Baugh, CSWP [spin] [americanflag]
3DVision Technologies
faq731-376
When in doubt, always check the help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top