Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Annular Orifice 1

Status
Not open for further replies.

TarnG

Mechanical
Joined
May 17, 2006
Messages
1
Location
GB
Would it be possible to use the annular orifice area to determine the equivalent bore of a cicular one, to then establish pressure drops/flow rates etc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top