Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Animation

Status
Not open for further replies.

harris0165

Structural
Joined
Mar 1, 2007
Messages
4
Location
US
I am working with ANSYS v11 and running my models through input files. I have most of the details worked out, but I cannot figure out how to stop an animation with a command once it has been started. Does anyone know if there is a command to do such a thing. Thanks
 
hello harris0165,
with which command do you start the animation?
I'm working with v.10 and I#m not sure is everything the same.
 
Hi,
You can use 'PLDI' and 'ANMODE' to start the animation.But I don't know the command to stop it. I made a simulation with GUI and tried to get the command from log file,but got nothing.Maybe the only way to stop it is the control box.

Rock Li
 
Thanks Rock. I have come to the same conclusion and just gave up. My end solutions was to cycle through the mode animations using a do loop at the very end upon completion of all of my analyses. It leaves that last animation running, but does not slow anything down because everything is done.
Regards,
D
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top