Anyone know how to animate a sheet metal thru a rollers, something like this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Animation of sheet metal rolling
- Thread starter ESTinker
- Start date
Typically this is done by varying parameters such that more of the part is on one side of the roller and less on the other and copying the screen at each small step and then using movie/animation software to put the individual images into an animation format.
This can be done using a sweep along the path. There can be other ways as well.
Deepak Gupta
SOLIDWORKS Champion and Expert
SW 2022 SP0.0, 2021 SP5.1 and 2020 SP5.0
Boxer's SOLIDWORKS Blog
Deepak Gupta
SOLIDWORKS Champion and Expert
SW 2022 SP0.0, 2021 SP5.1 and 2020 SP5.0
Boxer's SOLIDWORKS Blog
- Status
Similar threads
- Locked
- Question
- Locked
- Question