Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Angle stack-ups

Status
Not open for further replies.
Compa

Compa

Mechanical
Joined
Feb 12, 2003
Messages
1
Location
US
Does anybody know how to calculate the tolerance on an angle ie (x = 4+/- 0.1 y = 2+/-0.05). I can substitute the maximum and minimum values and get two answers, but is there any other way to do this?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top