Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Angle stack-ups

Status
Not open for further replies.

Compa

Mechanical
Feb 12, 2003
1
Does anybody know how to calculate the tolerance on an angle ie (x = 4+/- 0.1 y = 2+/-0.05). I can substitute the maximum and minimum values and get two answers, but is there any other way to do this?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor