E
etsiperros
Guest
Hi everyone,
I'm new on that so I'll try to explain my self properly
hehe.
I'm triying to do some finite element analysi withe the
modul Analysis & Simulation of Catia V5-16.
The problem comes around when I try to define the loads
on my figure. I'm working with an endlees worm and I have
to apply the loads not in the whole perimeter but in a
small surface, the one in contact with the gear. How can
I define this surface? I have try to project a plane on
the worm but it doesn't work properly.
I have the same problem when trying to analyze a spindle,
as I do have to apply the loads only in just a pair of
the threads and I don
I'm new on that so I'll try to explain my self properly
hehe.
I'm triying to do some finite element analysi withe the
modul Analysis & Simulation of Catia V5-16.
The problem comes around when I try to define the loads
on my figure. I'm working with an endlees worm and I have
to apply the loads not in the whole perimeter but in a
small surface, the one in contact with the gear. How can
I define this surface? I have try to project a plane on
the worm but it doesn't work properly.
I have the same problem when trying to analyze a spindle,
as I do have to apply the loads only in just a pair of
the threads and I don
