Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Analysis Feature Bug

  • Thread starter Thread starter agarfiel
  • Start date Start date
A

agarfiel

Guest
I've encountered a bug in Wildfire 5.0 (M060) that has to do with analysis features. If you have an analysis feature in your model tree (volume, length, etc...) and you insert mode above it or suppress it, it will corrupt any saves that you make while it is suppressed.


There is no warning of the issue while you're working. It will go through the save dialogue just fine. If you try to open that file again after closing Pro/E it will hard crash Pro/E (the program just disappears) andis notretrievable.


The only way to successfully save the file is if the analysis feature is not suppressed or inserted above when you save.


I've spoken with PTC and they've verified this issue, with no known date for when it'll be patched.


I just wanted to put this out on the boards since I couldn't find any answers in my initial search and troubleshooting of this issue. Hopefully it'll save someone else the headaches that I had.


Alex
 
I tried to reproduce this issue in WF4 M210 too, but there are no problems.


Regards, DonChunior
 
I just wanted to follow up that PTC has contacted me to say
this bug will be fixed in Creo Elements/Pro 5.0 release
M150, due out on July 27.

Alex
 

Part and Inventory Search

Sponsor

Back
Top