Mahlo
Industrial
- Jun 11, 2009
- 9
I am trying to do a simple moving average type smoothing of a 0-10VDC analog input on a DL05 (DirectSOFT 5 for programming). Is there an ibox that can accomplish this or do I have to do it the hard way?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
analog smoothing
- Thread starter Mahlo
- Start date
- Status
Probably have to do it the hard way in ladder logic but that will add lag time. Or you might find a low-pass filter signal conditioner somewhere that would accomplish this so that the signal to the PLC is smoothed out.
TygerDawg
Blue Technik LLC
Virtuoso Robotics Engineering
TygerDawg
Blue Technik LLC
Virtuoso Robotics Engineering
- Status